LOAD PULL TESTING SERVICES WE OFFER
- Anchor Load Pull Out Testing & Tensile Strength
- Shear Testing
- Surface Bond Testing
- Bolt / Anchor Bolt Testing
- Erection / Eye / Rawl Bolts
- Safety Wire Testing
- Stud Anchors & Resin Bolts
- Scaffold Ties
- Tension Testing
- Holding Down Bolts
HOW IT WORKS
Our pull out testing uses state of the art equipment that attaches to the exterior bolt, nut, screw or fixing. This is then pulled to the designated stress load level per provide blueprint drawings to determine how strong and secure the fixing is. Even though materials used for bonding may be different, this method remains the same for all types of fixings.
Roof Anchor Tension Tester – Roof Anchor Load Pull Testing
GHB Fall Protection Technicians are able to confirm the holding power of anchors in most construction materials using state of the art Load Anchor Testing equipment, either for the purpose of establishing safe working loads or to validate the correct installation of existing fixings.
Scaffold Testing Load Pull Testing
GHB Protection Services follows the standard guidelines for OSHA & Building Codes and we are able to test the anchorage systems for scaffolding to check the suitability and allowable loads of an anchor type in a particular base material and check that anchors have been installed correctly.
Eye and Ring-bolt Load Pull Testing
GHB Fall Protection Technicians are able to test each structural anchorage, after installation which will be pulled based on the blueprint drawings & load capacity to confirm the soundness of the fixing. This service is for testing safety harness bolts and can be applied to ladder restraint hooks and most bolts in concrete and masonry.
|Visit all GHB Companies & Services...|